| Subject | Text |
| Gents, l was working on the very same unit, with same problem.
Battling for 2 days and no luck.
|
| Can you measure resistance (Ohm) with your meter?
If so, a short should measure 0 - 10 Ohms
A go |
|
|
| Re: Goodmans GTV42P3 42" Plasma TV - Power Board Repair | [quote:ba34fe886c="Mad Professor"]Good Day All.
I have a 3 year old Goodmans GTV42P3 42" P |
| [quote:e6a73c2eac="opal"]Thanks for the Info,
i have to addmit, im not into Musik really, so i dont |
| [quote:780ca32676="Justmanuals"]This Parts & Service manual can now be purchased for $11.77 and |
| You can buy a ESR meter from MCM electronics for about $20.00 |
| Re: looking for | [quote:6e09f5f793="jts1957"]That's the "Location" and "Rating/Value" of [b:6e09f |
| Being a switchmode powersupply I would not run it without a load otherwise it may self destruct. Plu |
| Samsung 760V TFT Lower Half of Screen Darker than Top Half | This happens every so often and I have to turn the monitor off and on and it fixes it, works fine af |
| Vizio L32 | RTek,
thanks for the help. I had to put this one on the shelf for a bit. My current problem is t |
| Yikes! Now it's getting complicated! I found the Power Transistors and ordered them through
htt |
| Re: Viewsonic N3245W Black Screen - Need some help | I would like your old inverter board; have one with bad transformer on; can't find supply of board o |
| [quote:93e26ac61b="vtech"]Depends on your Amplifier drive capability; while it is not too far off, |
| Pioneer 52" Model#: SDP5183 | We just got this tv and you can turn in on and a few minutes later the picture will go off and all y |
| Your going to need a soldering iron with a thin tip, .050 solder wick, heat sink compound, and solde |
| Bush ws6671sil - 11AK19Pro chassis - Help needed! | Hello!
First off, this site is probably the most useful electronic repair site I have come across. |
| videocon microwave | Worth checking them anyway using a meter as they cause a lot of problems on all microwaves. |
|
|
| It sounds like it could be a capacitor related problem. Do you have an ESR meter to test them with? |
| Guys!
I had the exact same problem tonight with my Panasonic NV-DS65 after about 3 months of not u |
| LCD TV problem | Hi guys, I hope that someone can help. I have an LCD TV that works great when it works. It was given |
| Hello
You must meter output lines of power supply unit and check that their values being true (as s |
| the best procedure to check ultra fast diode by analogmeter | the best procedure to check ultra fast diode by analogmeter
what is the best procedure?
how t |
| There's no bulging caps that I can see on any of the boards, including the power supply.
So, I sh |
| Koss elect. complaint..Scrolls need help | My problem and question is my Koss KS3102 Home video and audio entertainment system.The volume needs |
| Epson Stylus Photo R360 printer | I've got an Epson Photo R360 printer and have always used compatible cartridges since they are a fra |
| PSU problem Infocus 5700 - heat up caps works | Hi all, I have an Infocus Screenplay 5700 projector with a PSU problem. It fails to startup unless I |
| Is it an Electrolytic ? If yes a esr meter, and or a capacitance meter. |
| Nd Svc Manuals - Fluke 8060A, Pana-KX-P4430laser | I looked here far and wide and have not found the manuals.
The KX-P 4430 is similar to several m |
| Hi Jouni that's great. And I've already found the procedure now. It is the same method that you de |
| Worked for me also. Great Job | Agatha,
Great Job my camera works well. After reading previous strings I had given hopes on my ca |